At Home Barista
Home / Guides / Brewing

Pour-over coffee at home: ratio, grind and timing

A cone dripper, a paper filter and a scale. Here is a recipe that works the first time, and what to change when it does not.

Brewing · Published 21 Nov 2026

POUR-OVER1:16
Coffee
20 g
Water
320 g
Grind
Medium-fine
Water temp
93 to 96 °C
Total time
About 3 min

Pour-over is the most forgiving way to get a clean, bright cup at home. You control the water, the timing and the grind, and the gear is cheap. The method below is a standard starting point for a cone-shaped dripper such as a V60 style. Treat the numbers as a first draft you adjust to your coffee and your taste.

What you need

  • A cone or flat-bottom pour-over dripper and matching paper filters
  • A kettle, ideally with a narrow spout so you can pour slowly
  • A scale that reads in grams, and a timer (many scales have one)
  • A burr grinder, or freshly ground coffee from a roaster or shop
  • A mug or a small server

The recipe

This makes one large mug. It uses a ratio of 1 part coffee to 16 parts water by weight, which sits in the middle of the range most brewers use.

  1. Heat the water. Bring it to a boil, then let it sit for 30 seconds. That lands around 93 to 96 °C (200 to 205 °F). For a very dark roast, wait a little longer so the water is slightly cooler.
  2. Rinse the filter. Fold the paper into the dripper, set it on your mug and pour hot water through it. This removes the papery taste and warms the mug. Pour the rinse water out.
  3. Grind 20 g of coffee to medium-fine, about the texture of table salt. Add it to the filter, give the dripper a gentle shake to level the bed and put it all on the scale. Zero the scale.
  4. Bloom. Start the timer and pour about 40 g of water, enough to wet every bit of coffee. Wait 30 to 45 seconds. You will see the bed puff and bubble as it releases gas. Fresh coffee blooms more.
  5. Pour in slow circles. Bring the scale to about 200 g by 1:15, then to 320 g by about 2:00. Pour from a low height, keep the water on the coffee and away from the paper walls.
  6. Let it draw down. The water should finish dripping through by about 2:45 to 3:30. Remove the dripper, swirl the mug and taste.

Fixing the result

What you seeWhat it usually meansTry this
Water drains in under 2 minutes and the cup tastes sharp or thinGrind too coarseGo one step finer
Draw-down takes over 4 minutes and the cup tastes dry or bitterGrind too fineGo one step coarser
Tastes fine but too strong or too weakRatio, not grindChange the coffee dose by 1 to 2 g, keep the rest

Change one thing at a time and write down what you did. Two or three brews of this coffee, taking notes, will teach you more than any chart. If you want the reasoning behind each fix, read why coffee tastes sour or bitter.

Common mistakes

  • Skipping the scale. A scoop of light roast and a scoop of dark roast weigh different amounts. Weighing removes the guesswork.
  • Pouring too fast. A fast pour lowers contact time and gives a thin cup. Slow down your pours.
  • Using stale pre-ground coffee. Ground coffee loses aroma quickly. If you can only change one thing, buy whole beans and grind them right before brewing.

Gear for this

Some links on this site are, or may become, affiliate links. If you buy through one we may earn a commission at no extra cost to you. It does not change what we write. Details.

Kitchen scale with timer

Reads in grams and tracks your pour time.

Pour-over dripper and paper filters

The dripper and the filters have to match in size and shape.

Gooseneck kettle

A narrow spout makes slow, steady pours easy.